Key installation points for dry-type transformers

Aug 13, 2024

Leave a message

Choose a transformer based on the electrical load:
1) The capacity of distribution transformers should be calculated based on the facility capacity of various electrical equipment, excluding fire loads. The compensated apparent capacity is the basis for selecting the capacity and number of transformers. The load rate of a typical transformer is around 85%. This method is relatively simple and can be used for estimating capacity.
2) In GB/T17468-1998 "Guidelines for the Selection of Power Transformers", it is recommended that the capacity selection of distribution transformers should be determined based on GB/T17211-1998 "Load Guidelines for Dry type Power Transformers" and the calculated load. The above two guidelines provide computer programs and normal cycle load diagrams to determine the capacity of distribution transformers.
Installation points
Distribution transformers are important components of substations, and dry-type transformers without enclosures are directly installed on the ground with protective barriers around them; Dry type transformers with shells can be installed directly on the ground. Refer to the national building standard design drawings for installation. 03D201-4 10/0.4kV transformer room layout and installation of commonly used equipment components in the substation.